naxdrink.blogg.se - Crack do pw clean 2.6.5

we often get questions such as "The AB is low, what should I do?".

Check the health of the chopper servo by running the "Top Hat" software checkįrequently Asked Questions General FAQs How much information does Aerodyne need to help me diagnose my problem?Ī: as much as possible.

Always keep the vacuum system operational, Don’t leave instrument in the powered down state for extended periods (> 1-2 weeks).

Avoid exposure to elements, especially sea salt.

Clean the instrument, particularly the raw aluminum chamber surface.

Check and tighten 80/20 (frame) fasteners after shipping.

Clean fan filters on all electronic components and Turbo Pump fans.

2.7.14 IE for BFSP and CPC-Squirrel methods are very different from each other (and/or IE changed a lot since last calibration).

2.7.13 Verifying potentiometer board power.

2.7.12 Troubleshooting heater power failure.

2.7.10 Calibrating heater power voltage.

2.7.8 I have problems with my heater voltages.

2.7.7 My heater current looks correct (1-1.1 A), but I don't think it is 600C.

2.7.4 I don't have a PToF Airbeam after I shipped the instrument.

2.7.3 I have MS, but not a PTOF airbeam.2.7.2 I see small reflection peaks following all peaks in my mass spectra and in the Bitwise SI trace.2.6.3 What is the pin-out on the ion optics cable?.2.6.1 What are the fuses in the TPS as well as TPS modules.2.5.13 Miscellaneous wiring and electronics diagrams, etc.2.5.11 Is there a diagram of all the voltages in the TOF ?.2.5.7 What are the pin-outs for the blue-connector cable leading from the 6024E card to the BNC terminal block?.2.5.6 What is the replacement for the dust filter in front of the fans on the electronics box.2.5.5 At which point were different updates to the AMS electronics introduced?.2.5.4 When can I turn on the filaments after venting?.2.5.3 How can I ship or store my MCPs under vacuum?.2.5.2 When can I turn on the MCP after venting?.2.3.12 How do I re-plumb my vacuum system?.2.3.10 Vacuum Interlocks for TPS and Vaporizer Automatic Shutoff.2.3.9 Proper Turbo Venting according to Varian.2.3.8 How do I replace a diaphragm on a MD1?.2.3.6 How can I check whether my instrument is leak-tight?.2.3.5 Can I keep a spare turbo pump in its box for a year?.2.3.4 If one turbo pump fails can I keep running the system?.2.3.2 What are your backing pump pressure and lens pressure?.2.3.1 What are the operating currents for all pumps?.2.1.4 Is there a general diagram of the signals and connections in the ToF-AMS?.2.1.3 I have questions about what the AMS data mean.2.1.2 I have questions about AMS Software.

2.1.1 How much information does Aerodyne need to help me diagnose my problem?.